G Loading Paper In The Bypass Tray; Loading Paper In The Bypass Tray - Sharp AR-C260 Operation Manual

LOADING PAPER

Loading paper in the bypass tray

The bypass tray can be used to feed the same paper specified for paper tray 1 or for special papers. For paper types
that can be used in the bypass tray, see the specifications for the bypass tray in the paper tray specifications (page
2-9).
Up to 250 sheets of SHARP standard paper or up to 100 postcards can be set in the bypass tray.
NOTE
G After loading the paper in the bypass tray, be sure to set the paper type and size (step 4) if these were changed.
G Do not use inkjet paper. This may cause misfeeds in the fusing unit.
1 Open the bypass tray.
Be sure to pull the tray extension all the way out. If
the tray extension is not pulled all the way out, the
size of the paper loaded in the bypass tray may not
display correctly.
2 Set the bypass tray guides to the width of
the copy paper.
2-4
When loading paper that
will extend past the end
of the tray, pull out the
tray extension to support
the paper and to allow the
paper sensors to properly
sense the paper size.
To support papers that
extend past the tray
extension, pull out the
wire extension.
3 Insert the copy paper all the way into the
bypass tray. (Do not force the paper in.)
smudges on succeeding copies. Special purpose
papers other than
transparency film must be fed individually. Multiple
sheets of SHARP recommended transparency
film can be loaded in the bypass tray.
4 Set the type and size of the paper loaded in
the bypass tray.
If you loaded a different type of paper from the
previous paper, be sure to set the new paper type
as explained in "Setting the paper type and paper
size in the bypass tray" (page 2-12). If you loaded
a special size of paper in the bypass tray, set the
paper size as explained in "Setting the paper size
when an extra size is loaded" (page 2-11).
(If you do not set a size, part or all of the image
may not print.)
5 This completes the procedure for loading
paper in the bypass tray.
NOTES
Place the copy paper
face up. If the bypass
tray guides are set
wider than the copy
paper, the inside of the
machine may become
soiled, resulting in
SHARP recommended
When loading paper in
the bypass tray or
closing the tray, close
the paper cover as
shown.