Control Installation; Through The Wall Mounting - Baldor 22H series Installation & Operating Manual

Section 1
General Information

Control Installation

Through the Wall Mounting

3-4 Receiving & Installation
The control must be securely fastened to the mounting surface. Use the four (4)
mounting holes to fasten the control to the mounting surface or enclosure.
Control sizes E and F are designed for panel or through the wall installation. To mount a
control through the wall, an optional Through the Wall mounting kit must be purchased.
These kits are:
Kit No. Description
V0083991 Size E control Through the Wall mounting kit.
V0084001 Size F control Through the Wall mounting kit.
Procedure:
1. Refer to Section 7 of this manual for drawings and dimensions of the Through
the Wall mounting kits. Use the information contained in these drawings to
layout the appropriate size hole on your enclosure and wall.
2. Cut the holes in your enclosure and wall.
3. Locate and drill holes for mounting hardware as shown in the drawings.
4. Cut foam tape and apply to perimeter of opening as shown.
5. Secure the four (4) brackets to the exterior of the panel with the hardware
provided.
6. Secure the control to the panel using the hardware provided.
MN722