Initialize New Firmware - Baldor 22H series Installation & Operating Manual

Section 1
General Information
Program Mode Continued

Initialize New Firmware

Action
Apply Power
Press PROG key
Press Y or
key
Press ENTER key
Press Y or
key
Press ENTER key
Press Y key
Press ENTER key
Press Y key
Press ENTER key
Press Y key
Press ENTER key
Press DISP key several
times
Press ENTER key
Press DISP key
Press DISP key
4-10 Programming & Operation
After new firmware is installed, the control must be initialized to the new firmware version
and memory locations. Use the following procedure to Initialize the firmware.
Description
Keypad Display shows this
opening message.
If no faults and programmed for
LOCAL operation.
Enter program mode.
Scroll to Level 2 Blocks.
Select Level 2 Blocks.
Scroll to the Miscellaneous block.
Select Miscellaneous block.
Scroll to Factory Settings
parameter.
Access Factory Settings
parameter.
Scroll to YES, to choose original
factory settings.
Restores factory settings.
Scroll to menu exit.
Return to display mode.
Scroll to diagnostic information
screen.
Access diagnostic information.
Display mode showing software
version and revision installed in
the control.
Displays exit choice.
Display
Logo display for 5 seconds.
Display mode. Stop LED on.
V
represents blinking cursor.
"Loading Presets" is first message
"Operation Done" is next
"No" is displayed last.
Display mode. Stop LED on.
If you wish to verify the software
version, enter diagnostic info.
Displays commanded speed,
direction of rotation, Local/
Remote and motor speed.
Verify new firmware version.
Press ENTER to exit diagnostic
information.
Comments
MN722