0 B G Lobally Acknowledging Alarms; 1 B I Ndividually Acknowledging Alarms - Simplex 4100ES Operator's Manual

Acknowledging an Alarm,
G lobally
5 0 B
Acknowledging
Alarms
I ndividually
5 1 B
Acknowledging
Alarms
Continued
Use the following procedure if the Global Acknowledge option is enabled on your system.
1. Unlock and open the enclosure door. Read the alphanumeric display on the interface panel.
It reports the number of alarm conditions as shown below.
**FIRE**
Fire =1
2. Press the Fire Alarm Ack key. Read and follow the instructions on the alphanumeric
display. After you press the Fire Alarm Ack key, the system responds as follows:

The tone-alert silences and the alphanumeric display reports pertinent information about
the alarm, such as the following:
FIRST FLOOR EAST WING
PULL STATION

The Fire Alarm LED changes from flashing to steady ON, and all alarm conditions are
acknowledged.

Pressing the Fire Alarm Ack key again displays information on the next alarm.
Continue to do this to review all alarms in the system.
Use the following procedure if the Individual Acknowledge option is enabled on your system.
1. Unlock and open the enclosure door. Read the alphanumeric display on the interface panel.
It reports the number of alarm conditions as shown below.
**FIRE**
Fire =1
2. Press the ALARM ACK key. A report similar to the one shown below appears. Read and
follow the instructions on the alphanumeric display.
FIRST FLOOR EAST WING
Press ACK key to acknowledge ALARM
Press <ACK> to review.
PRI2 = 0
Press <ACK> to review.
PRI2 = 0
PULL STATION
SUPV = 0 TRBL=0
ROOM 31
FIRE ALARM
SUPV = 0 TRBL=0
ROOM 31
ALARM
Continued on next page
7