Simplex 4100ES Operator's Manual page 50

Generating Reports,
Overview
Continued
Report
TrueAlert Status Report
TrueAlarm CO Report
Install Mode List Report
Alarm Verification Tally
Report
TrueAlert ES Self-Test
Report
TrueAlert ES Speaker Tap
Report
Table 6-1. Reports (continued)
This report can be created after the TrueNAC Voltage
Drop Test (see Chapter 7) is run. It reports the following
information for each Multi Candela TrueAlert Device.

Point ID.

Custom Label.

Pass/Fail.
Report the following information for each SLC:

Nominal Current (A) - The current draw on the
TrueAlert circuit when the test was run.

Worst Case Current (A) - The current draw on the SLC
under worst case operating conditions.

Worst Case voltage Above/Below threshold (V).
This report provides the following information regarding
the CO devices:

Device Number (on the network).

Custom Label (custom description of device).

Current Device Value (PPM).

End-of-Life Date.

Device Status (Normal, Trouble).
This report provides the following information
regarding the Install Mode list:

Point ID.

Custom Label.

Device Status.
This report provides the following information for each
device supporting alarm verification:

Device Number.

Custom Label.

Device Type.

Point Type.

Tally Count.
This report provides the following information for devices
that support Self-Test:

Point ID.

Custom label.

Test date.

Self-Test result.
This report provides the following information for NXNA
speaker devices:

Point ID.

Custom label.

Device type.

Speaker tap position.
Description
40