ABB ProcessMaster FEP611 Operating Instructions Manual page 69

Error no. / Error text
Range
C078.004 / Flowrate to zero.
Config. Check digital in terminals.
C076.006 / All totalizer stopp.
Config. Check digital in terminals.
C074.007 / Totalizer reset.
Config. Reset of one or more
Totalizers.
C072.003 / Simulation is on Simulated
Config. values.
Switch off Simulation Mode.
C070.027 / An alarm is simulated.
Switch off alarm simulation.
Config.
Inhouse temp. alarm.
S065.044 /
Reduce ambient
Operation
temperature.
S064.041 / EPD alarm.
Operation Secure pipe is completely
filled.
S062.039 / Sensor temp. limits alarm.
Change limits or change fluid
Operation
temperature.
S052.017 / Curr.Out 31 / 32 is
Operation saturated.
CO process value out of
range. Adapt Qmax.
S047.016 / Pulse output is cut off.
Operation Wrong config. Check pulse
out configuration.
S046.001 / Mass flowrate exceeds
Operation limits.
Check flowrate and alarm
limits.
S044.002 / Volume flowrate exceeds
Operation limits.
Check flowrate and alarm
limits.
S041.034 / DC feedback regulation.
Electronics Check conditions of
application. Call service.
S040.031 / Coil impedance alarm.
Electronics Call service.
Current output Digital output
4 mA (0 % flow) Current value - no
change.
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
Current value - no No response
change.
Alarm - as Alarm if DO is
configured in configured as
menu "Curr. at "Logic / Alarm
EPD Alarm". Signal / EPD".
Current value - no No response
change.
Alarm - as Current value - no
configured in change.
menu "Curr.Out >
20.5mA".
Current value - no Current value - no
change. change.
Current value - no Alarm if DO is
change. configured as "Qm
Massflow Max" or
"Qm Massflow
Min".
Current value - no Alarm if DO is
change. configured as "Qv
Volumeflow Max"
or "Qv Volumeflow
Min".
4 mA (0 % flow) No response.
Current value - no No response.
change.
ProcessMaster FEP610, HygienicMaster FEH610 | OI/FEP610/FEH610-EN Rev. B 69
Pulse output LCD display
0 Hz 0 %
Current value - Current value -
no change. no change.
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
No response Current value - no
change.
0 0 %
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
Maximum possible Current value - no
pulse rate change.
Current value - no Current value - no
change. change.
Current value - no Current value - no
change. change.
0 Hz 0 %
Current value - no Current value - no
change. change.
Error maskable?
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".
Menu "...Group
Masking".