ABB ProcessMaster FEP611 Operating Instructions Manual page 36

Easy Setup
Pulse Width
30.00 ms
Next
22. Use to call up the edit mode.
23. Use / to set the desired pulse width.
24. Confirm the selection with
Easy Setup
Damping
30.00 ms
Next
25. Use to call up the edit mode.
26. Use / to set the damping for the volume flow.
27. Confirm the selection with
Easy Setup
Dig.Out 41 / 42 Mode
Pulse
Next
28. Use to call up the edit mode.
29. Use / to select the desired operating mode (Off,
Logic, Pulse, Frequency) for the digital output.
30. Confirm the selection with
Easy Setup
Curr.Out at Alarm
High Alarm
Next
31. Use to call up the edit mode.
32. Use / to select the desired alarm mode.
33. Confirm the selection with
Change from two to one column
36 OI/FEP610/FEH610-EN Rev. B | ProcessMaster FEP610, HygienicMaster FEH610
Edit
.
Edit
.
Edit
.
Edit
.
Easy Setup
Low Alarm
3.500 mA
Next
34. Use to call up the edit mode.
35. Use / to set the alarm current for "Low Alarm".
36. Confirm the selection with
Easy Setup
High Alarm
21.800 mA
Next
37. Use to call up the edit mode.
38. Use / to set the alarm current for "High Alarm".
39. Confirm the selection with
Zero point adjustment of the flowmeter
NOTE
Prior to starting the zero point adjustment, make sure that:
— There is no flow through the sensor (close valves, shut-
off devices etc.).
— The sensor is completely filled with the medium to be
measured
Easy Setup
System Zero
Next
— Use to start automatic balancing of the zero point for
the system.
Menu
Easy Setup
Exit Select
Once all parameter have been set, the main menu appears
again. The most important parameters are now set.
40. Use to switch to the process display.
Edit
.
Edit
.
OK