ABB ProcessMaster FEP611 Operating Instructions Manual page 62

Menu / parameter
Diagnostics / ...Diagnosis Control / ...Noise Check
Start Noise Check
Power Spectrum
Amplitude 1 Value
Amplitude 2 Value
Amplitude 3 Value
Amplitude 4 Value
Frequency 1
Frequency 2
Frequency 3
Frequency 4
Diagnostics / ...Diagnosis Control / ...Fingerprints
Tx Factory CMR
Tx Factory 1m/s
Tx Factory 10m/s
Start Tx Customer FP
Tx Customer CMR
Tx Customer 1m/s
Tx Customer 10m/s
Diagnostics / ...Diagnosis Values
All values in this menu are for information / service purposes only.
Inhouse Temperature
Inhouse Temp MaxPeak
Inhouse Temp MinPeak
Driver Current
Signal Region on ADC
Coil DAC Preset
DC Feedback DAC
ADC Errors
Device Restart Count
62 OI/FEP610/FEH610-EN Rev. B | ProcessMaster FEP610, HygienicMaster FEH610
Description
Start the "Noise Check" function using
Current power spectrum.
Display the four highest amplitudes in the power spectrum.
Display the corresponding frequency to those four highest amplitudes in the power spectrum.
The "fingerprint" database allows to compare the values at the time of factory calibration with the currently recorded
values. Errors in the integrity of the "Tx Factory 1m/s" device can be detected at an early stage.
Corrective actions can be taken.
Create the manual fingerprint for the transmitter using
The manual fingerprint is created on site prior to verification of the transmitter.
Use the parameter "Start Tx Customer FP" to create the the manual fingerprint.
Indicates temperature inside the Transmitter housing.
Indicates Sensor Coil drive current.
Indicates the measuring signal within the AD-converter Input.
(-100% .... +100%)
Indicates DA-converter for coil drive.
DA-converter feedback value.
AD-converter errors.
Numbers of device restarts (Boots).
.
.