Menu: Process Alarm - ABB ProcessMaster FEP611 Operating Instructions Manual

Menu / parameter
Input/Output / Dig.Out 51 / 52 / ...Setup Logic Output
Logic Output Action
Active Mode
Input/Output / Dig.Out 51 / 52 / ...Alarm Config
General Alarm
Qv Volumeflow Max
Qv Volumeflow Min
EPD
7.5.7

Menu: Process Alarm

Menu / parameter
Process Alarm
Diagnostic history
Clear Alarm History
...Group Masking
...Alarm Limits
Process Alarm / ...Group Masking
Maintenance Required
Function Check
Out Of Specification
Process Alarm / ...Alarm Limits
Qm Massflow Min
Qm Massflow Max
Qv Volumeflow Min
Qv Volumeflow Max
60 OI/FEP610/FEH610-EN Rev. B | ProcessMaster FEP610, HygienicMaster FEH610
Description
Selection of binary output function.
See description "Input/Output / Dig.Out 41 / 42- / ...Setup Logic Output".
Select switching properties for the binary output.
— Active High: Normally open.
— Active Low: Normally closed.
Select error messages signaled via the binary output 51 / 52.
Only if the parameter "Logic Output Action" is set to Alarm Signal.
Default setting: Off.
Description
Shows the alarm history list.
Reset of the alarm history.
Selection of submenu "...Group Masking" using
Selection of submenu "...Alarm Limits" using
Alarm messages are divided into groups.
If masking is activated for a group (On), no alarm is issued.
For further information, see chapter "
Diagnosis / error messages" on page 64.
Sets the minimum / maximum limit value (0 ... 110 %) for mass measurement. If the process value "Qm [unit]"
exceeds or falls below the limit value, an alarm is triggered.
Sets the minimum / maximum limit value (0 ... 110 %) for volume measurement. If the process value "Qv [unit]"
exceeds or falls below the limit value, an alarm is triggered.
.
.