2N Indoor Talk User Manual page 82

Brightness Setting Mode
Brightness setting mode
Doorbell Activation
Doorbell Doorbell
activation activation
2N TELEKOMUNIKACE a.s., www.2n.cz
Brightness
intensity up
press
Brightness
intensity
press
down
Brightness
confirmation
press
simultaneously
for 3 seconds
or press
Selection
cancelling
press
When the doorbell input is activated, the selected tune
will be played. Applies to all the modes. You can change
the doorbell ringtone in the Services / User sounds
section via the user interface.
Each button press increases the
brightness intensity, which is
signalled by a beep. When the
maximum intensity is reached,
the symbol flashes three times.
Each button press decreases the
brightness intensity, which is
signalled by a beep. When the
minimum intensity is reached,
the symbol flashes three times.
Press the button(s) to confirm
the selected brightness level.
The buttons start shining with
the confirmed brightness
intensity and two beeps are
used for signalling. You can also
idle for 10 s to confirm your
selection and quit the mode.
Press the button to cancel the
brightness intensity selection
and quit the mode without
saving. If the setting is
interrupted by an incoming call,
the brightness intensity set
before the changes is restored.
82/90