2N Indoor Talk User Manual page 21

®
Take 2N Indoor Talk
mounting box. First plug the green doorbell/power connector and then the LAN
connector. Put the cables carefully in the pre-drilled
prevent them from blocking any horizontal levelling movement during the final
installation stage. Insert
clicks onto the levelling pins, which allow for a 5–6
accurate horizontal levelling. Apply the box screw nuts with the hexagon key wrench
provided. Level 2N
®
Now 2N Indoor Talk
®
2N Indoor Talk consumption with variable power supplies:
Supply type
PoE, IEEE 802.3af
12 V / 2 A
Warning
Do not connect any external power supply if PoE is used and vice versa.
If you use a power adapter other than the recommended one, do not
exceed the 12 V rated supply voltage. Also check the supply voltage
polarity. Higher voltage values or misconnections may result in an
irreplaceable device damage.
2N TELEKOMUNIKACE a.s., www.2n.cz
and lean its bottom edge against the wall below the flush
®
2N Indoor Talk
®
Indoor Talk with a water level and tighten the screws gently.
is ready for basic operation.
Consumption
12 W
12 W
®
2N
in the flush mounting box making sure that it
° inclination on either side for
Indoor Talk back slot to
21/90