2N Indoor Talk User Manual page 23

PoE Supply Connection
Use a standard straight RJ-45 terminated cable to connect
Ethernet. The device supports the 10BaseT and 100BaseT protocols. The Ethernet
connection state is indicated by the
flashes, the device is disconnected from the network.
Caution
Factory reset results in a change of the Ethernet interface configuration!
A defective Ethernet cable may lead to a high packet loss in the
Ethernet and subsequent instability and poor call quality!
Warning
Do not connect an external power supply if PoE is used and vice versa.
Connection of a defective or improper power supply may lead to a
temporary or permanent device failure.
2N TELEKOMUNIKACE a.s., www.2n.cz
2N
symbol (hung-up receiver). If the symbol
®
Indoor Talk to the
23/90