2N Indoor Talk User Manual page 61

VLAN Enabled – enable the virtual network support (VLAN according to 802.1q).
Remember to set the VLAN ID too.
VLAN ID – choose a VLAN ID from the range of 1–4094. The device shall only
receive packets with the set ID. An incorrect setting may result in a connection
loss and subsequent factory reset.
Required Port Mode – set the LAN port mode to be preferred: Automatic or Half
Duplex – 10 Mbps, which reduces the bit rate to 10 Mbps in case the available
LAN cabling is unreliable for a 100 Mbps traffic.
Current Port State – current LAN port state: Half or Full Duplex – 10 Mbps or 100
Mbps.
Verify the network address accessibility – check the accessibility of a given address in
the LAN via the Ping command like in common operating systems. Press Ping to
display a dialogue for you to enter the IP address/domain name and press Ping to
send the test data to the set address. If the IP address/domain name is invalid, a
warning is displayed and the Ping button remains inactive until the IP address
becomes valid. The dialogue also displays the procedure state and result. Failed
means that either the IP address was unavailable within 10 s or it was impossible to
translate the domain name into an address. If a valid response is received, the
response sending IP address and response waiting time in milliseconds are displayed.
Press Ping again to send another query to the same address.
2N TELEKOMUNIKACE a.s., www.2n.cz 61/90