Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Harrow Assembly Installation
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Install harrow hanger arms to rear of frame using
u-bolts and 5/8-11 hex lock nuts
and
See Figures 2-1
frame.
2. Attach harrow arms to harrow hanger arms by
placing 1/2-13 x 4 hex head cap screws through the
4th hole in both harrow arms. Secure with 1/2-13 hex
lock nut.
IMPORTANT
Allow enough slack in screw so harrow arms may
pivot freely.
3. Connect harrow arms together through bottom hole
using 1/2-13 x 2-1/2 hex head cap screw, spacer
bushing, and hex lock nut.
3-32
See Figures 3-23
through
2-6
for location on
4.
Install harrow springs and chains as shown in
Figure 3-23
using 1/2-13 x 4 hex head cap screws
and hex lock nuts. The top spring is anchored in the
1st hole from the top. Front lower spring and rear
lower spring are anchored in the 7th hole from the
top of the harrow arm. Upper chain is anchored
through the enlarged link with a 1/2-13 x 2-1/2 hex
head cap screw and hex lock nut and hooked on the
spring in the 8th link from the bolt. Lower chains are
anchored in the second from bottom harrow arm hole
and hooked on the spring in the 4th link from the
screw.
5. Attach harrow adjustment bracket between harrow
arms using 1/2 x 2 clevis pin and 5/32 x 1-1/4 cotter
pin.
5. Attach harrow adjustment brackets to harrow
sections with 1/2-13 x 1-1/2 hex head cap screws
and hex lock nuts
See Figures 2-13
for location on frame.
IMPORTANT
Refer to operating instructions for angle adjustment
See Figure
4-12.
See
through
2-18
F-1072-0320
Advertisement
Table of Contents
