Inspecting The Probe And Its Accessories - Keysight InfiniiMax III+ Series User Manual

1
Using InfiniiMax III+ Series Probes

Inspecting the Probe and Its Accessories

The N2830/1/2A and N7000/1/2/3A InfiniiMax III+ probes are shipped with a case,
calibration information, probe handling guide, and probe information card that are
shown in
shipped items are shown in these figures. After opening the case, lift out the foam
cutout and flip the cutout over to reveal an calibration envelope and a handling
guide.
When you receive your probe, check the following items:
• Inspect the shipping container for damage.
• Check the accessories.
• If the contents are incomplete or damaged, notify your Keysight Technologies
• Inspect the probe. If there is mechanical damage or defect, or if the probe does
If the shipping container is damaged, or the cushioning materials show signs of
stress, notify the carrier as well as your Keysight Technologies Sales Office. Keep
the shipping materials for the carrier's inspection. The Keysight Technologies
office will arrange for repair or replacement at Keysight Technologies' option
without waiting for claim settlement.
6
Figure 2 on page 7 or
Keep the damaged shipping container or cushioning material until the contents of the
shipment have been checked for completeness and the probe has been checked
mechanically and electrically.
Sales Office.
not operate properly or pass calibration tests, notify your Keysight Technologies
Sales Office.
Figure 3 on page 8. Most, but not all, of the
InfiniiMax III+ Series Probes User's Guide