N2836A Infiniimode Solder-In Head - Keysight InfiniiMax III+ Series User Manual

2
Using InfiniiMax III+ Probe Heads

N2836A InfiniiMode Solder-In Head

The N2836A InfiniiMax III solder-in probe head
(26 GHz) is an economical semi-permanent
connection. This is an InfiniiMode probe head (like
the N2848A) which allows you to make differential,
common mode, and single ended measurements
without having to re-solder the tip leads. Because
this is an InfiniiMode compatible head, the tip has
two signal leads and two ground leads. To learn
about InfiniiMode, refer to
page 22.
The ground leads have minimal effect on differential measurements. However, if
you are making only differential measurements you can optionally cut off the
ground leads or fold them out of the way. If you have older N2836A probe heads,
you can easily add ground leads.
The variable span of the tip leads ranges from 5 mil to 250 mil (0.127 mm to
6.35 mm).
Table 14 Bandwidth
Probe Amplifier
N2830A
N2831A
N2832A
N OT E
For performance plots, refer to
N OT E
60
"To Use InfiniiMode"
BW
4 GHz
8 GHz
13 GHz
To install or repair N2838A resistor leads, refer to
on page 76.
Tips"
Chapter
on
Probe Amplifier
N7000A
N7001A
N7002A
N7003A
"Replacing Axial Resistor
6, "Performance Plots.
InfiniiMax III+ Series Probes User's Guide
BW
8 GHz
13 GHz
16 GHz
16 GHz