Table of Contents
Advertisement
Introduction
The InfiniiMax III and III+ Probing System Family Diagram,
shows compatible oscilloscopes, probes, and probe heads. The
connect to the oscilloscope using a precision-BNC connection (AutoProbe 1).
N7000/1/2/3A probes connect to the oscilloscope using a 3.5 mm connection (AutoProbe
2).
Table 1
Probe
N2832A
N2831A
N2830A
Both the
when using the N2848A QuickTip probe head, N2836A Solder-in head or N5444A
2.92 mm/SMA head. InfiniiMode allows you to switch between differential,
single-ended, and common mode measurements without needing to change or
reconnect the probe or probe leads. Switching measurements is accomplished
using the oscilloscope's probe configuration dialog box. For more information,
refer to
Before using the probe, refer to
WARNING
Probe heads
Before you can use the probe, you must connect one of the available probe heads
that are shown in
InfiniiMax III+ Probe Heads". These probe heads are also compatible with the
InfiniiMax III N2800A-series probes.
Before using the probes, refer to
CAUTION
Differential probe heads offer easy measurement of differential signals and greatly
improve the measurement of single-ended signals. Single-ended probe heads
offer extremely small size for probing single-ended signals in confined spaces.
InfiniiMax III+ Series Probes User's Guide
Figure 5
on page 11 and
Probe Bandwidths
AutoProbe 1 (Precision BNC)
Scope Connection
Bandwidth
13 GHz
8 GHz
4 GHz
N2830/1/2A and N7000/1/2/3A probes support InfiniiMode
InfiniiMax III+
"To Use InfiniiMode"
Figure 4
Figure 6
on page 12 identify most of the probe parts.
Probe
N7003A
N7002A
N7001A
N7000A
on page 22.
"Safety Information"
on page 10 and documented in
"To Avoid Damaging the Probe"
Using InfiniiMax III+ Series Probes
Figure 4
on page 10,
N2830/1/2A probes
The
AutoProbe 2 (3.5 mm)
Scope Connection
Bandwidth
20 GHz
16 GHz
13 GHz
8 GHz
on page 34.
Chapter
2, "Using
on page 16.
1
9
Advertisement
Table of Contents
