Introduction; Inspecting The Probe Shipment; Oscilloscope Compatibility; Cleaning The Probe - Keysight N2862B User Manual

Introduction

Introduction

Inspecting the Probe Shipment

• Inspect the shipping container for any damage.
• Check the accessories.
• If the contents are incomplete or damaged, notify your Keysight Technologies
• Inspect the probe. If there is mechanical damage or defect, or if the probe does
• If the shipping container is damaged, or the cushioning materials show signs of

Oscilloscope Compatibility

These probes are compatible with any Keysight real-time oscilloscope that has a 1
MΩ input resistance.

Cleaning the Probe

Disconnect the probe from the oscilloscope and clean it with a soft cloth
dampened with a mild soap/water solution. Do not allow any solution to enter the
probe. Make sure the probe is completely dry before reconnecting it to an
oscilloscope.

Handling the Probe

Before using the probe, refer to the safety notices
4
Keep the damaged shipping container or cushioning material until the contents
of the shipment have been checked for completeness and the probe has been
checked mechanically and electrically.
Sales Office.
not operate properly, notify your Keysight Technologies Sales Office.
stress, notify the carrier as well as your Keysight Technologies Sales Office.
Keep the shipping materials for the carrier's inspection. The Keysight
Technologies office will arrange for repair or replacement at Keysight
Technologies' option without waiting for claim settlement.
The probe tip and ground spring are sharp. Handle these items with
WARNING
care to avoid personal injury.
(page
N2862B, N2963B, N2889A, and N2890A User's Guide
11) in this manual.