Inspecting The Probe; Cleaning The Probe; Handling The Probe - Keysight N2791A User Manual

Inspecting the Probe

❏ Inspect the shipping container for damage.
Keep the damaged shipping container or cushioning material until the contents
of the shipment have been checked for completeness and the probe has been
checked mechanically and electrically.
❏ Check the accessories.
• If the contents are incomplete or damaged, notify your Keysight Technologies
Sales Office.
❏ Inspect the instrument.
• If there is mechanical damage or defect, or if the probe does not operate
properly or pass calibration tests, notify your Keysight Technologies Sales
Office.
• If the shipping container is damaged, or the cushioning materials show signs
of stress, notify the carrier as well as your Keysight Technologies Sales Office.
Keep the shipping materials for the carrier's inspection. The Keysight
Technologies office will arrange for repair or replacement at Keysight
Technologies' option without waiting for claim settlement.

Cleaning the Probe

Disconnect the probe and clean it with a soft cloth. Make sure the probe is
completely dry before reconnecting it to an oscilloscope. Avoid using abrasive
cleaners and chemicals containing benzene or similar solvents.

Handling the Probe

!
Handle the probe with care and refer to the safety notices at the back of this
manual and on page 9. Note that the probe cable is a sensitive part of the probe
and, therefore, you should be careful not to damage it through excessive bending
or pulling. You should also avoid any mechanical shocks to this product in order
to guarantee accurate performance and protection.
Inspecting the Probe
3