Table of Contents
Advertisement
Installing and connecting the device
3.2 Installing the device
Procedure
Identification date
Order number
Serial number
Manufacturing version
Microsoft Windows Product Key
Ethernet address 1, MAC address
Ethernet address 2, MAC address
1. Copy the order number, serial number and manufacturing version in the table listed
above.
2. Copy the Windows "Product Key" to the table.
3. Copy the Ethernet addresses from the component label to the table.
The Ethernet addresses can also be found in the BIOS setup (F2 key) under "Main >
System Information", entries "LAN 1 MAC" and "LAN 2 MAC".
3.2
Installing the device
3.2.1
Installation information
NOTICE
Risk of fire
If you install the device in an unapproved mounting position or if you do not observe the
ambient conditions, the device can overheat. Conformity with the low voltage directive
becomes void.
Device overheating can cause a fire. Proper functioning of the device is no longer
guaranteed.
Before you install the device, note the following general installation information.
Note
If the equipment is used in a manner not specified by the manufacture, the protection
provided by the equipment might be impaired.
28
Source
Rating plate
Rating plate
Rating plate
COA label
BIOS setup > "Main" menu
or:
Component label
Operating Instructions, 09/2018, A5E41134132-AE
Value
6AG4012-1 ...
s XXX 1234...
FS
⑤
⑥
SIMATIC IPC347E
Advertisement
Table of Contents
