Procedure
1. If you are installing a 3.5" drive or hard disk, attach two mounting brackets or a 3.5"/5.25"
mounting rack for the drive.
2. Remove the retaining screws and remove the cover plate for the expansion drive.
3. Secure the drive to the slot
The screws to be installed on the right side of the slot are highlighted in the figure below.
4. Install the driver cage again.
5. Connect the power and data cables to the drive.
SIMATIC IPC347E
Operating Instructions, 09/2018, A5E41134132-AE
①
②
or
with 4 screws.
Installing hardware expansions
5.3 Disk drives
47