Installing The Device; Installation Guidelines - Siemens SIMATIC IPC PX-39A Operating Instructions Manual

3.2

Installing the device

3.2.1

Installation guidelines

Procedure during installation and mounting
Dangerous voltage and fire hazard
Improper actions during installation and assembly may lead to personal injury and/or
substantial damage to equipment.
You should observe the installation and assembly notes under:
• Notes on mounting (Page 23)
• Notes on ambient and environmental conditions (Page 23)
NOTICE
Insufficient load carrying capacity
If the wall it is mounted on does not have a sufficient load-bearing capacity, the device may
fall and be damaged.
• Ensure that the mounting surface on the wall can bear four times the total weight of the
NOTICE
Incorrect fixing elements
The device may not be securely fitted if you use fixing elements other than those specified
below for mounting. The device can fall and may be damaged.
• Use only the specified fixing elements.
Note
• See the notes under Preparing the mounting cutout (Page 33).
• For installation in control cabinets, note the SIMATIC setup guidelines as well as the
• Provide adequate volume in the control cabinet for air circulation and heat transport. Keep
• The ventilation slots of the device may not be covered or obstructed.
• Ensure there is enough clearance in the control cabinet to allow the backplane cover to be
• Equip the control cabinet with struts for stabilizing the mounting cut-out. Install struts
See also
Mounting positions (Page 32)
SIMATIC IPC PX-39A
Operating Instructions, 08/2022, A5E51699601-AA
WARNING
device, including fixing elements.
relevant DIN/VDE requirements or the country-specific regulations.
at least 50 mm distance between the device and control cabinet.
removed.
where necessary.
Installing and connecting the device
3.2 Installing the device
35