Removing The Power Supply - Siemens SIMATIC IPC347E Operating Instructions Manual

Note
The configuration data of the device are deleted when the battery is replaced. Note the
current BIOS setup settings.
Replacing the battery
The location of the backup battery on the motherboard and the procedure for replacing the
backup battery are described in the chapter Jumpers (Page 84) and chapter Battery socket
(Page 96).
Reconfiguring the BIOS setup
When a battery is replaced, the configuration data of the device is deleted and must be
reconfigured in the BIOS setup.
6.4.4

Removing the power supply

Requirement
● The device is disconnected from the mains.
● The top cover is opened.
● All connection cables are unplugged.
● PH2 screwdriver
Procedure
SIMATIC IPC347E
Operating Instructions, 09/2018, A5E41134132-AE
6.4 Removing and installing hardware components
1. Disconnect the power supply cables of the
drives and the motherboard.
2. Remove the cable ties securing the power
cables in the housing.
3. Remove the retaining screws
4. Remove the power supply of the housing
from the top.
Device maintenance
①
.
57