Siemens SIMATIC IPC347E Operating Instructions Manual page 107

SATA controller
You can enable and disable SATA device with SATA controller.
Follow the instruction below to enable or disable the SATA controller
1. Select SATA controllers with the arrow keys and press Enter key.
2. Select Enabled or Disabled as you need and press Enter key in the active window pop-
up.
3. Press F4 key and save the change.
IDE legacy/native mode selection
You can configure IDE to a particular mode as the following instructions.
1. Select IDE Legacy/Native Mode Selection with the arrow keys and press Enter key.
2. Select Native or Legacy as you need and press Enter key in the active window pop-up.
3. Press F4 key and save the change.
USB configuration
In USB configuration page, you can view and configure USB parameters.
USB device
The USB device shows the USB device detected by BIOS during POST. If there is no device
attached to the motherboard, only 2 Hubs is shown.
USB support
Follow the instruction below to enable or disable the USB support.
1. Select USB support with the arrow keys and press Enter key.
2. Select Enabled or Disabled as you need and press Enter key in the active window pop-
up.
3. Press F4 key and save the change.
Legacy USB support
Follow the instruction below to enable or disable the USB support.
1. Select Legacy USB support with the arrow keys and press Enter key.
2. Select Enabled, Disabled or Auto as you need and press Enter key in the active window
pop-up.
3. Press F4 key and save the change.
See the options for legacy USB support below:
Option
Auto
Enabled
Disabled
SIMATIC IPC347E
Operating Instructions, 09/2018, A5E41134132-AE
Description
This option disables Legacy USB Support if there is no USB device is connected.
This option enables Legacy USB Support.
This option keeps USB device available only for EFI application.
Appendix BIOS
B.3 Advanced setup
107