NEC Express5800 series User Manual page 129

9. Install the device into the bay as follows (see Figure 4-36):
!
Move any cables in the bay out of the way.
!
Align the rails on the media device with the supports in the bay.
!
Slide the device into the bay until it locks in place.
!
Connect the power cable (B) and data cable (A) to the device.
C
A Data Cable
B Power Cable
Figure 4-36. Installing a Removable Media Device
10. Grasp the edge of the front subchassis.
11. Depress and hold the spring clip down and swing the front chassis all the
way into the main chassis.
12. Install the front access cover, rear access cover and front panel following
procedures previously described in this chapter.
13. Plug in the power cords and power up the system.
14. Run the BIOS Setup to configure the device.
C
A
C Slide Rails
Upgrading Your System 4-47
B