NEC Express5800 series User Manual page 81

3. Remove the rear access cover following procedures described in Chapter 4
of this guide.
4. Remove the processor access cover following procedures described in
Chapter 4 of this guide.
5. Remove the spare jumper from pins 1 and 2 on system function jumper
block, see Figure 3-1.
6. Install the spare jumper on pins 9 and 10 (Password clear) of system
function jumper block.
7. Reinstall the rear access cover and processor access cover removed in steps
3 and 4 above. See Installing the Rear Access cover and Processor Access
Cover in chapter 4.
8. Reinstall ac power cords and power up the system. While waiting for POST
to complete, press the F2 key to enter BIOS setup. This automatically clears
CMOS, provided you exit and save the BIOS setup.
9. Repeat steps 2, 3 and 4 of these procedures.
10. Remove the jumper you just installed on the system function jumper block
and place it back on pins 1 and 2 as the spare jumper.
11. Reinstall the rear access cover and processor access cover removed in steps
3 and 4 above. See Installing the Rear Access cover and Processor Access
Cover in chapter 4.
12. Reinstall ac power cords and power up the system. While waiting for POST
to complete, press the F2 key to enter BIOS setup.
13. If specifying a new password, run the BIOS Setup Utility as described
earlier in this chapter.
Configuring Your System 3-29