Installing A Power Supply Module - NEC Express5800 series User Manual

Installing a Power Supply Module

To install a power supply module:
1. If present, remove the filler panel from the vacant slot.
2. Holding the power supply latch handle in the open position, slide the power
supply module into the vacant slot until you feel resistance.
The module engaging its connector causes the resistance.
To avoid damaging the module, do not tilt or twist the power
supply module as you push it into the connector.
3. Guide the power cord through the strain relief notch in the latch handle and
plug the cord into the AC power connector on the back of the power supply
module.
4. Press the latch handle down to engage the latches and secure the power
supply to the chassis.
5. Insert and tighten the four screws that secure the power supply module to the
chassis.
6. Connect the AC power cord to the wall outlet or other AC power source.
The green LED on the power supply module should be illuminated.
! CAUTION
Upgrading Your System 4-41