NEC Express5800 series User Manual page 150

Table 5-1. POST Error Codes and Messages (continued)
Error Code and Message
0B94 IPMB Error
0B95 BMC FRU device
failure
0B96 BMC SDR
Repository failure
0B97 BMC SEL device
failure
0B98 BMC RAM test error BMC RAM test error
0B99 BMC Fatal hardware
error
0B9A Management
Controller error
0B9B Private I2C error
0B9C BMC internal
exception
0B9D BMC A/D timeout
error
0B9E SDR repository
corrupt
0B9F SEL corrupt
0BB0 SMBIOS - SROM
data read error
0BB1 SMBIOS - SROM
data checksum bad
0BC0 Post detected
startup failure of
CPU #1
0BC1 Post detected
startup failure of
CPU #2
0BC2 Post detected
startup failure of
CPU #3
0BC3 Post detected
startup failure of
CPU #4
5-18 Problem Solving
Description
IPMB signal lines do not respond
Access to SROM that contains the
chassis information failed
Access to FMEM sector that
contains SDR information failed
BMC SEL device failure
BMC Fatal hardware error
Management Controller not
responding
Private I2C bus not responding
BMC internal exception
BMC A/D timeout error
SDR repository corrupt
SEL corrupt
Read error of SROM data
Checksum for the SROM data is
incorrect
CPU #1 failed to start up
CPU #2 failed to start up
CPU #3 failed to start up
CPU #4 failed to start up
Action
All the functions other than the function
of accessing to SMC through IPMB can
be used. This is not a fatal error. Turn
off the power once and then on again to
restart the server. If the error cannot be
corrected, contact your service
representative.
All the functions other than the function
of accessing to SMC through IPMB can
be used. This is not a fatal error. Turn
off the power once and then on again to
restart the server. If the error cannot be
corrected, contact your service
representative.
Turn OFF server power source once
and then on again to start the server. If
the error cannot be corrected, contact
your service representative.
Contact your service representative.
Contact your service representative to
replace the failed CPU.