Installing The Rear Access Cover; Removing The Front Access Cover - NEC Express5800 series User Manual

Installing the Rear Access Cover

Note:
you have not left tools or loose parts inside the system.
To install the rear access cover:
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Position the cover on the chassis so that the cover tabs align with the chassis
slots.
3. While lightly pressing the cover against the chassis, slide it toward the front
of the chassis until the cover tabs fully engage the chassis slots.
4. Attach the cover to the chassis with the captive fasteners located on the rear
edge of the cover.

Removing the Front Access Cover

The front access cover provides access to the hot-swap fans, to devices in the
peripheral bay, and to the hot-swap drive bay. To remove the front access cover:
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Remove the rear access cover following procedures previously described in
this chapter.
3. Release the two screws, as shown in Figure 4-3, A.
4. Lift the rear edge of the cover slightly and slide it toward the rear of the
chassis.
5. Lift the cover up and off of the chassis.
Figure 4-3. Removing the Front Access Cover
Before installing the rear access cover, check that
A
Upgrading Your System 4-7