Chapter 2 Installation And Setup; Overview; Installing The Bbg-1022-Fs-Dsp; Installing Using Bbg-1000-Tray Optional Mounting Tray - Cobalt Digital Inc BBG-1022-FS-DSP Product Manual

Overview

Installing the BBG-1022-FS-DSP

Installing Using BBG-1000-TRAY Optional Mounting Tray

BBG-1022-FS-DSP-OM (V1.2)
Installation and Setup
Chapter 2
This chapter contains the following information:
Installing the BBG-1022-FS-DSP (p. 2-1)
•
Rear Panel Connections (p. 2-2)
•
GPIO, Serial (COMM), and Analog Audio Connections (p. 2-5)
•
Note: • Where BBG-1022-FS-DSP is to be installed on a mounting plate (or regular
table or desk surface) without optional frame Mounting Tray
BBG-1000-TRAY, affix four adhesive-backed rubber feet (supplied) to the
bottom of BBG-1022-FS-DSP in locations marked with stamped "x". If feet
are not affixed, chassis bottom cooling vents will be obscured.
• Where BBG-1022-FS-DSP is to be installed with optional frame Mounting
Tray BBG-1000-TRAY, do not affix adhesive-backed feet.
BBG-1000-TRAY
securely attached to a 1 RU tray that fits into a standard EIA 19" rack
mounting location. Install BBG-1022-FS-DSP unit into tray as described and
shown here.
If installing BBG-1022-FS-DSP using optional frame Mounting Tray
1.
BBG-1000-TRAY, install BBG-1022-FS-DSP in tray as shown in
Figure 2-1.
Connect the input and output cables as shown in Figure 2-3.
2.
BBG-1022-FS-DSP PRODUCT MANUAL
allows up to three BBG-1022-FS-DSP to be mounted and
Chapter 2
2-1