Table of Contents
Advertisement
Overview
Installing the 9927-2StoH Into a Frame Slot
9927-2STOH-OM (V1.0)
Installation and Setup
Chapter 2
This chapter contains the following information:
Installing the 9927-2StoH Into a Frame Slot (p. 2-1)
•
Installing a Rear I/O Module (p. 2-3)
•
Setting Up 9927-2StoH Network Remote Control (p. 2-5)
•
CAUTION
Heat and power distribution requirements within a frame may dictate specific
slot placement of cards. Cards with many heat-producing components should
be arranged to avoid areas of excess heat build-up, particularly in frames
using only convection cooling. The 9927-2StoH has a high power dissipation
with maximum frame loading recommendations as follows:
• OG3 Frame: (5) cards
• HPF-9000 Frame: (5) cards
• oGx Frame: (7) cards
CAUTION
Note:
If installing the 9927-2StoH in a slot with no rear I/O module, a Rear I/O
Module is required before cabling can be connected. Refer to Installing a
Rear I/O Module (p. 2-3) for rear I/O module installation procedure.
9927-2STOH PRODUCT MANUAL
This device contains semiconductor devices which are
susceptible to serious damage from Electrostatic
Discharge (ESD). ESD damage may not be immediately
apparent and can affect the long-term reliability of the
device.
Avoid handling circuit boards in high static environments
such as carpeted areas, and when wearing synthetic fiber
clothing. Always use proper ESD handling precautions
and equipment when working on circuit boards and
related equipment.
Chapter 2
2-1
Advertisement
Table of Contents
Troubleshooting
