Chapter 2 Installation And Setup; Overview; Setting I/O Switches For Aes I/O (1-4) Ports - Cobalt Digital Inc 9061 Product Manual

Overview

Setting I/O Switches for AES I/O (1-4) Ports

9061-OM (V4.9)
Installation and Setup
Chapter 2
This chapter contains the following information:
Setting I/O Switches for AES I/O (1-4) Ports (p. 2-1)
•
Installing the 9061 Into a Frame Slot (p. 2-2)
•
Installing a Rear I/O Module (p. 2-4)
•
Setting Up 9061 Network Remote Control (p. 2-10)
•
Note: This procedure is applicable only if any of the four AES I/O (1-4) ports on the
9061 are to be used as outputs (the switches are set to input mode by factory
default). The 9061 is equipped with a four-section red DIP switch that sets
AES pairs 1 thru 4 as either inputs or outputs. The factory default position is
the input position for each pair.
• If all of the AES I/O (1-4) ports are to be used as inputs (or not used at all),
omit this procedure.
• If any of the AES I/O (1-4) ports are to be used as outputs, set the switches
as described in this procedure.
Note switch S11 thru S14 settings for
in Figure 2-1. For port to be used as an output, set switch to down position as
shown in Figure 2-1.
Note: Regardless of S11 thru S14 settings for AES I/O 1 thru AES I/O 4, outputs
AES OUT (1-8) are still available on cards equipped with a Rear I/O Module
having dedicated AES OUT (1-8) BNC connectors.
9061 PRODUCT MANUAL
Chapter 2
AES I/O 1 thru AES I/O 4 mode shown
2-1