Programming; Basic Configuration - NEC Univerge UM8000 Installation Manual

Issue No. 1.0
P
S 4
ROGRAMMING
ECTION
4.1
7 - 2

Basic Configuration

Program/
Item No.
10-09-01 DTMF and Dial Tone Circuit Setup
Department Group Pilot Numbers choose Department
11-07-01
Group and define Pilot Number
Service Code Setup (for Service Access), Flash on
Trunk Lines This code is used for Centrex Transfer
11-12-42
using Digital voice mail ports. If this code starts with #
then 45-01-05 must be set to 0 (Off).
14-01-22 Basic Trunk Data Setup – Caller ID to Voice Mail
14-02-10 Analog Trunk Data Setup – Caller ID
15-02-08 Message Waiting LED Color
Multiline Telephone Basic Data Setup, MSG Key
15-02-26
Operation Mode
Single Line Telephone Basic Data Setup - SLT
15-03-01
Signaling Type set all Voice Mail ports to 0 (DP)
Single Line Telephone Basic Data Setup - Terminal
15-03-03
Type set all Voice Mail ports to Special
Single Line Telephone Basic Data Setup -Caller ID
15-03-09
Function for External Module
15-07-01 Programmable Function Keys
16-01-01 Department Name
16-01-04 Hunting Mode
16-01-10 Enhanced Hunt Type
Department Group Assignment for Extensions put all
Voice Mail ports in Group Number used in 11-07-01
and assign priorities
16-02-01
When setting up hunt group priorities the VM ports
must be assigned as port 1 = priority 1, port 2 =
priority 2 and so on. Failure to do this will cause the
VM to answer but no audio will be heard.
System Options for Multiline Telephones - Disconnect
20-02-09
Supervision
Call Queuing, turn off or on an extension ability to
20-09-07 have calls queued if a call rings the extension when it
is busy.
Description
Setting Up Integration (SV8100)
UM8000
Required
X
X
X