Using Dial-Up Connection; Using Winscp And Dial-Up To Connect Remotely - NEC Univerge UM8000 Installation Manual

UM8000
3.2
Installation Manual
2. Right-click My Network Places, and select Properties.
The Network Connections window appears.
3. Right-click Local Area Connection, then select Properties.
The Local Area Connection Properties window appears.
4. Double-click Internet Protocol (TCP/IP).
5. On the General tab:
a Select Use the following IP address.
b Type 172.16.1.200 in the IP address field.
c Type 255.255.255.0 in the Subnet mask field.
d Leave the Default gateway field blank.
e Click OK.
The Internet Protocol properties dialog box closes.
6. Click OK to close the Local Area Connection window.

Using Dial-up Connection

The procedures in this section assume that the network administrator has
helped set up the remote computer for remote dial-up access and that you
know how to dial-in to the network.
3.2.1

Using WinSCP and Dial-up to Connect Remotely

Use the following procedure to transfer files between the voice
messaging system and a remote computer.
1. On the Windows Desktop, double-click the Dial-up connection
icon.
The Connect page appears. If you are using a network connection,
go to step 6.
2. In the User name field, type admin.
3. In the Password field, type the password: voicemail.
4. Click Dial.
The modem dials the phone number. If the connection is
successful, a small icon with two flashing computers appears On
the Windows taskbar.
NOTE
5. On the Windows taskbar, click Start > Programs > WinSCP3 >
WinSCP.
The Login window appears.
Consult your network administrator for assistance setting up
dial-up access to the network.
Issue No. 1.0
11 - 3