Setting Up Os/2 Netbios Backup For Migration; Configuring Netbios Over Tcp/Ip - NEC Univerge UM8000 Installation Manual

UM8000
1.4
Installation Manual

Setting up OS/2 NetBIOS Backup For Migration

Network protocols must be installed to back up an OS/2 voice messaging
system using a NetBIOS over TCP/IP.
A NetBIOS over TCP/IP configuration is required for a an OS/2 voice
messaging system network backup. Activation or upgrade codes are not
required for network backups.
Make sure that the following installation information is available before starting
the NetBIOS backup for migration:
OS/2 voice messaging system
1.4.1

Configuring NetBIOS over TCP/IP

Configure TCP/IP and specify a Windows network domain name. If a
domain does not exist, use the procedure described in Section
Setting Up a Remote Windows Computer for a Backup on page 13-10
in this chapter.
For a network backup using NetBIOS over TCP/IP, set up the system
to log on to the network. After installing network protocols, refer to
Section 1.4.2 Setting Up an OS/2 Voice Messaging System to Log On
to a Network on page 13-8
Finally, set up a Windows computer to share a drive with the OS/2
voice messaging system. Refer to Section
Windows Computer for a Backup on page 13-10
NOTE
Set up the Windows system as a workgroup environment with a
unique TCP/IP address.
1.4.1.1 Installing Network Protocols for a NetBIOS Backup
1.
2.
3.
4.
Subnet mask
Router
Domain name
Server name
TCP/IP address
in this chapter.
Log on to the OS/2 voice messaging system. The
Banner page appears.
Press ESC on the Banner page and follow the
system prompts.
Start an OS/2 command prompt.
On the OS/2 command prompt, type f: <ENTER>.
Issue No. 1.0
1.5
1.5 Setting Up a Remote
in this chapter.
13 - 5