Using Putty From Winscp; Putty; Installing Putty - NEC Univerge UM8000 Installation Manual

UM8000
P
S 3
U
ECTION
3.1
Installation Manual
2. Click Session.
3. Type the Host name (or IP address), User name, and Password.
NOTE
4. Click SAVE to save the login information for future sessions.
5. Click LOGIN.
A potential security breach message might appear, click YES .
The WinSCP console appears.
2.2.2

Using PuTTY from WinSCP

This procedure assumes that PuTTY is installed. Refer to
Section 3.1 Installing
1. In WinSCP, click Commands > Open in PuTTY.
When the first connection is made, a PuTTY security alert appears.
The alert does not appear in subsequent connections. Click Yes .
The PuTTY window appears with a password prompt.
2. Type the admin password: voicemail.
When a connection is established, the Maintenance menu appears.
To use PuTTY without WinSCP, refer to
TTY

Installing PuTTY

After configuring the TCP/IP settings, run a PuTTY SSH client on the remote
computer to connect to the voice board, and complete the software
configuration.
NOTE
nly PuTTY and WinSCP SSH clients are supported.
O
The following procedures assume that PuTTY will be installed on a computer
running the Windows XP operating system and it is being installed from the
Support disc.
Use this procedure to install PuTTY on the voice messaging system, a client
computer, or on a remote computer.
The IP address for the voice mail is assigned in chassis
programming 10-55-xx. At default this address is
172.16.1.xxx, where .xxx is the slot where the CD-VM00 is
installed. Slot 1 is .100, slot 2 is .101, slot 5 is .104, and so
on. The user name: admin, and password: voicemail

PuTTY.

Issue No. 1.0
.
Section 3 PuTTY.
2 - 3