Overview; Setting Up Integration; Assign Extension Numbers To Voice Messaging Ports; Enabling Digital Voice Messaging Support - NEC Univerge UM8000 Installation Manual

Setting Up Integration (SV8300)
O
S 1
VERVIEW
ECTION
This chapter describes setup and programming for integrating the SV8300
telephone system and the voice messaging system.
S
S 2
ETTING
ECTION
Several tasks are required to integrate UM8000 with the phone system.
Use the phone system programming interface (either a CAT phone or a
SV8300 PCPro) to enter the phone system programming commands
below.
Follow all the procedures in this section in the order presented.
2.1
2.2
Installation Manual
U I
P NTEGRATION

Assign Extension Numbers to Voice Messaging Ports

Assign extension numbers to the voice messaging ports. The
UM8000 blade occupies ports AABB01 to AABB08 for an 8-port
system, and ports AABB01 to AABB16 for a 16-port system.
Command Code: 1000
First Data: AABBXX
Where AA = Chassis,
BB = Slot,
XX = Port.
Second Data: Fxxx
Where F specifies a digital extension and
<xxx> is the voice messaging port extension
number.
NOTE
Repeat this command for each port on the UM8000 blade.

Enabling Digital Voice Messaging Support

1. Enable AAInfo for incoming calls.
Command Code: 08
First Data: 702
Second Data: 0
8
8 - 1