Ring/Network Coupling
Select "Two-Switch coupling" by means of the dialog button with the
same graphic as below
2
STAND-BY
Figure 32: Two-Switch coupling
1: Coupling port
2: Partner coupling port
The following settings apply to the Switch displayed in blue in the
selected graphic.
Select the coupling port
With "Coupling port" you specify at which port you are connecting
the network segments:
You will find the port assignment for the redundant coupling in
table
11.
For a device with DIP switches, you switch the STAND-BY switch to
ON or deactivate the DIP switches. You connect the redundant line
to the coupling port.
Note: Configure the coupling port and the redundancy ring ports on different
ports.
Activate the function in the "Operation" frame
The displays in the "Select port" frame mean:
– "Port mode": The port is either active or in stand-by mode.
– "Port state": The port is either active, in stand-by mode or not
connected.
– "IP Address": The IP address of the partner, if the partner is already
operating in the network.
UM RedundConfig L2P
Release 8.0 05/2013
(see figure
1
ON
(see figure
5.2 Preparing a Ring/Network
32).
31).
(see figure 31)
Coupling
75