Hirschmann RS20 User Manual page 32

Ring Redundancy
show hiper-ring
HIPER Ring Mode of the Switch.................. ring-manager
configuration determined by.................. management
HIPER Ring Primary Port of the Switch.......... 1/1, state active
HIPER Ring Secondary Port of the Switch........ 1/2, state active
HIPER Ring Redundancy Manager State............ active
HIPER Ring Redundancy State (red. exists).. no (rm is active)
HIPER Ring Setup Info (Config. failure)........ no error
HIPER Ring Recovery Delay...................... 500ms
 Now proceed in the same way for the other two devices.
Note: If you have configured VLANS, note the VLAN configuration of the ring
ports.
In the configuration of the HIPER-Ring, you select for the ring ports
– VLAN ID 1 and "Ingress Filtering" disabled in the port table and
– VLAN membership U in the static VLAN table.
Note: Deactivate the Spanning Tree protocol for the ports connected to the
HIPER-Ring, because Spanning Tree and Ring Redundancy affect each
other.
If you used the DIP switch to activate the function of HIPER-Ring, RSTP is
automatically switched off.
 Now you connect the line to the ring. To do this, you connect the 2 devices
to the ends of the line using their ring ports.
The displays in the "Redundancy Manager Status" frame mean:
– "Active (redundant line)": The ring is open, which means that a data
line or a network component within the ring is down.
– "Inactive": The ring is closed, which means that the data lines and
network components are working.
32
3.1 Example of a HIPER-Ring
Display the HIPER-Ring parameters.
UM RedundConfig L2P
Release 8.0 05/2013