Hirschmann RS20 User Manual page 38

Ring Redundancy
enable
configure
mrp new-domain
default-domain
MRP domain created:
Domain ID:
255.255.255.255.255.255.255.255.255.255.255.255.255.255.255.255
(Default MRP domain)
mrp current-domain
port primary 1/1
Primary Port set to 1/1
mrp current-domain
port secondary 1/2
Secondary Port set to 1/2
mrp current-domain mode
manager
Mode of Switch set to manager
mrp current-domain recovery-
delay 200ms
Recovery delay set to 200ms
mrp current-domain advanced-
mode enable
Advanced Mode (react on link change) set to Enabled
mrp current-domain
operation enable
Operation set to Enabled
exit
show mrp
Domain ID:
255.255.255.255.255.255.255.255.255.255.255.255.255.255.255.255
(Default MRP domain)
Configuration Settings:
Advanced Mode (react on link change).... Enabled
Manager Priority........................ 32768
Mode of Switch (administrative setting). Manager
Mode of Switch (real operating state)... Manager
Domain Name............................. <empty>
Recovery delay.......................... 200ms
Port Number, Primary.................... 1/1, State: Not Connected
Port Number, Secondary.................. 1/2, State: Not Connected
VLAN ID................................. 0 (No VLAN)
Operation............................... Enabled
38
3.2 Example of a MRP-Ring
Switch to the privileged EXEC mode.
Switch to the Configuration mode.
Creates a new MRP-Ring with the default domain
ID
255.255.255.255.255.255.255.255.255.255.255.
255.255.255.255.255.
Define port 1 in module 1 as ring port 1 (primary).
Define port 2 in module 1 as ring port 2
(secondary)
Define this device as the ring manager.
Define 200ms as the value for the "Ring
Recovery".
Activate the "MRP Advanced Mode".
Activate the MRP-Ring.
Go back one level.
Show the current parameters of the MRP-Ring
(abbreviated display).
UM RedundConfig L2P
Release 8.0 05/2013