Ring/Network Coupling
Figure 25: One-Switch coupling: Selecting the port and enabling/disabling
operation
Note: The following settings are required for the coupling ports (you
select the Basic Settings:Port Configurationdialog):
See table 3 on page 30.
Note: If VLANs are configured, set the coupling and partner coupling
ports' VLAN configuration as follows:
– in the dialog Switching:VLAN:Port Port VLAN ID 1 and „Ingress
Filtering" deactivated
– in the dialog Switching:VLAN:Static VLAN-Membership U
(Untagged)
Redundancy mode
In the "Redundancy Mode" frame, select
– "Redundant Ring/Network Coupling" or
– "Extended Redundancy".
68
5.2 Preparing a Ring/Network
(see figure 26)
UM RedundConfig L2P
Release 8.0 05/2013
Coupling