Hirschmann RS20 User Manual page 18

Link Aggregation
 Proceed as follows to configure a link aggregation from 3 twisted pair
lines on device 3:
 Select the Redundancy:Link Aggregation
dialog.
Figure 3: Creating the link aggregation
 Select Allow static link aggregation if the partner device
does not support the Link Aggregation Control Protocol (LACP) (e.g.
MACH 3000).
 Click "Create entry" to create a new link aggregation.
 The Index column shows you the ID under which the device uses
a link aggregation (a trunk) as a virtual port. The device creates the
port in module 8, which does not physically exist, and the first link
aggregation then has the ID 8.1.
 The Name column allows you to give this connection any name you
want. In this example, you give the new link aggregation the name
"LAPT".
 The Enabled column allows you to enable/disable a link
aggregation that has been set up. Leave the checkmark in the
"Enabled" column while you are using the link aggregation.
18
2.1 Example of link aggregation
(see figure 3)
UM RedundConfig L2P
Release 8.0 05/2013