Maintenance - Ranger DST-64T Installation And Operation Manual

Maintenance

Make sure your Wheel Balancer is maintained on a regular basis.
Regular Maintenance
⚠
WARNING
To maintain your Wheel Balancer:
• Daily: Make sure the unit is clean and dry before using it.
• Weekly: Make sure the Shaft Assembly is correctly oriented with the Shaft Housing (witness
marks aligned) and is securely tightened.
• Monthly: Make sure all Anchor Bolts are tightened and secure.
• Monthly: Check all components to make sure they are in good operating condition. If you find a
component that is
Troubleshooting
• Every three months: Check the bolts on the components attached to the rear of the unit to
make sure they are tight and secure.
• Yearly: Have an Electrician come out and check the electronic components.
• Yearly: Take the unit out of service, disconnect the Power Cord from the power source, and then
thoroughly check and clean all components.
⚠
WARNING
DST-64T / DST642D Wheel Balancers
Disconnect the Power Cord from power
maintenance
and take whatever steps are necessary to make sure the unit
cannot be re-energized until Maintenance is over. Because the unit uses electricity,
you could be electrocuted or even killed if the unit is powered back on during
Maintenance.
not working correctly, take the unit out of service and refer to
for more information.
Do not operate your Wheel Balancer if you find issues; instead, take the unit out of
service, then contact your dealer, visit rangerproducts.com/support/, or call
(805) 933-9970.
before performing any
46
P/N 5900192 — Rev. F — March 2021