2. Free the harness [1] from the harness guide [2].
• 3 connectors [3]
• 2 fixing guides [4]
• 1 wire saddle [5]
3x
[1]
3x
[2]
CAUTION:
When the fixing assembly is installed, handle the
harness [1] like the figure to prevent papers from the
interference at the transit.
[1]
[1]
[4]
[5]
[3]
[3]
3. Remove the Fixing Assembly [1].
• 2 screws [2]
2x
[2]
Removing the Fixing Film Unit
■ Preparation
1. Removing the Right Cover.(Refer to
Right Cover" on page
2. Removing the Left Cover.(Refer to
Left Cover" on page 118
3. Removing the Rear Upper Cover.(Refer to
"Removing the Rear Upper Cover" on page
4. Removing the Rear Cover.(Refer to
Rear Cover" on page
5. Removing the Rear Lower Cover.(Refer to
"Removing the Rear Lower Cover" on page
6. Removing the Rear Cover Rib Unit.(Refer to
"Removing the Rear Cover Rib Unit" on page 125
7. Removing the Duplex Printing Reverse Drive Unit.
(Refer to
"Removing the Duplex Reverse Drive Unit"
on page
179)
8. Removing the Fixing Assembly.(Refer to
the Fixing Assembly" on page
201
4. Disassembly/Assembly
[1]
"Removing the
120)
"Removing the
)
123)
"Removing the
123)
123)
"Removing
200)
[2]
)