Canon MF720 Series Service Manual page 294

Item
Adj/set/operate method
Display/adj/set range
Unit
Default value
Related service mode
SPL68677
Title
Details
Adj/set/operate method
Display/adj/set range
Unit
Default value
Related service mode
SPL25607
Title
Details
Adj/set/operate method
Display/adj/set range
Unit
Default value
Related service mode
SPL93822
Title
Details
Adj/set/operate method
Caution
Display/adj/set range
Default value
Related service mode
SPL78788
Title
Details
Adj/set/operate method
Caution
Display/adj/set range
Default value
Related service mode
SPL41250
Title
Details
Use case
Adj/set/operate method
COPIER > FUNCTION > SPLMAN
1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
COPIER > FUNCTION > SPLMAN > SPL65677
Increase of paper right and left margins
To increase the margin on the right and left of paper.
As the value is incremented by 1, the margin is increased by 0.1 mm.
The value obtained by adding this value and SPL25607 (decrease of the margin) is applied.
1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
COPIER > FUNCTION > SPLMAN > SPL25607
Decrease of paper right and left margins
To decrease the margin on the right and left of paper.
As the value is incremented by 1, the margin is decreased by 0.1 mm.
The value obtained by adding this value and SPL68677 (increase of the margin) is applied.
1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
COPIER > FUNCTION > SPLMAN > SPL68677
Setting of department ID count all clear
To set whether to disable clearing of all department ID counts.
1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Be sure to perform this mode after consulting with the system administrator at user's site.
0 to 1
0: Disabled
1: Enabled
0
COPIER > FUNCTION > SPLMAN > SPL78788
Setting of department ID count clear
To set whether to disable clearing of department ID count.
1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Be sure to perform this mode after consulting with the system administrator at user's site.
0 to 1
0: Disabled
1: Enabled
0
COPIER > FUNCTION > SPLMAN > SPL93822
Reset of calibration
When the user allows printing at absence of toner, calibration using toner is disabled.
As a remedy, calibration reset is executed by this switch.
When the user allows printing after absence of toner is displayed.
Select the item, and then press Applt key.
Description
286
8. Service Mode