Removing The Main Controller Support Plate - Canon MF720 Series Service Manual

5. Migrating the serial number
1. Enter the serial number (8-digit alphanumeric) in
Settings/Registration > System Settings > Device
Information > Location.
2. Execute the following service mode, and write the
serial number entered in the previous step on the
Main Controller PCB.
COPIER > OPTION > SERIAL > SN-MAIN
After it has been written, the serial number entered
in "Location" is deleted.
3. Turn OFF and then ON the main power.
4. Execute the following service mode, and check the
serial number on the System Management Data
List that was output (Body. No.).
COPIER > FUNCTION > MISC-P > SPEC
6. Migrating user data and service mode data
1. Enter service mode, and set the following item to
"1".
• COPIER > OPTION > USER > SMD-EXPT
NOTE:
The [SMD-EXPT] setting can be specified either from the
Control Panel or from the remote UI.
2. Using the DCM function (Refer to
Information Export/Import Function (DCM)" on
page 58), restore the following information.
• User data (the settings of the [Settings/
Registration] menu and the address book)
• Service mode setting information
3. Enter service mode, and set the following item to
"0".
• COPIER > OPTION > USER > SMD-EXPT
NOTE:
The [SMD-EXPT] setting can be specified either from the
Control Panel or from the remote UI.
7. Reinstall the drivers.
NOTE:
MAC address information is changed after replacement of
the Main Controller PCB. Therefore, when the PC and the
machine are connected by the network, the PC will not be
able to recognize the machine on the network. When the
PC and the machine are connected by the USB memory
device, the PC will not be able to recognize the machine
if the USB ID is changed. It becomes therefore necessary
to reinstall the driver.
"Setting
In the case of a model without fax for EUR (MF724Cdw),
perform the following works.
NOTE:
After replacing the Main Controller PCB, the value of
the service mode (SDTM-DSP) to set whether to
display or hide the automatic shutdown menu
becomes "0" (default value).
In that case, the automatic shutdown menu is not
displayed on the LUI of the machine.
To display the automatic shutdown menu on the LUI
of the machine, it is necessary to execute this
process.
8. Setting of automatic shutdown menu display
9. Turn OFF and then ON the main power.
10. Checking the setting of Auto Sleep Time
Support Plate
■ Preparation
1. Removing the Right Cover.(Refer to
161
1. Uninstalling Old Drivers.
• Printer Driver
• FAX Driver
• Scanner Driver
• Network Scan Utility. (for machines with
network connection)
* As for the procedure, refer to "Uninstalling the
Software" in the Starter Guide.
2. Refer to the following items in the Startup Guide
and install the drivers which were uninstalled.
• In case of network connection: "Installing via
Network Connection"
• In case of USB connection: "Installing with
USB Connection"
Set 1 for automatic shutdown menu display in service
mode (default: 0).
COPIER > OPTION > BODY > SDTM-DSP
In setting menu, check that the setting value of Auto
Sleep Time is 1. (If the setting value is 0, automatic
shutdown does not work.)
Menu > Timer Settings > Auto Shutdown Time
Removing the Main Controller
Right Cover" on page 120)
4. Disassembly/Assembly
"Removing the