Fixing Film Unit; Before Removing The Fixing Film Unit; Removing The Fixing Film Unit - Canon LBP3250 Series Service Manual

[4]
6) Remove the harness holder [1].
- 1 claw [2]
7) Remove the fixing assembly [1].
- 3 screws [2]
[2]
Point to Note at Installation
When installing the fixing harness, be sure to wrap the fixing harness [2]
around the projection [1] of the harness holder to secure with the harness
guide [3].
[2] [3]
[5]
[1]
[1]
F-3-59
[2]
[1]
F-3-60
[1]
[2]
F-3-61
[1]
Point to Note at Installation
When installing the terminal [1], be sure to make it in contact with the
contact spring [2] as shown in the figure below.
[2]

3.5.2 Fixing Film Unit

3.5.2.1 Before Removing the Fixing Film Unit

1) Remove the upper cover. (page 3-2)Reference[Removing the Upper
Cover]
2) Remove the left cover. (page 3-1)Reference[Removing the Left Cover]
3) Remove the right cover. (page 3-1)Reference[Removing the Right Cov-
er]
4) Remove the rear cover. (page 3-1)Reference[Removing the Rear Cover]
5) Remove the main controller PCB. (page 3-8)Reference[Removing the
Main Controller PCB]
6) Remove the fixing unit. (page 3-16)Reference[Removing the Fixing
Unit]

3.5.2.2 Removing the Fixing Film Unit

1) Disconnect the connector [1] and free the harness [3] from the harness
Chapter 3
[2]
[3]
[1]
0019-8451
0019-8452
3-17