Vermeer BC1200XL Operator's Manual page 94

Step 10: Retract winch line to move limb forward
until it reaches feed rollers.
Step 11: Briefly press Hold-to-Run Button (5) to start
limb into feed rollers.
When limb is in the grip of the feed rollers,
Step 12:
release Hold-to-Run Button (5).
WARNING: Failure to detach chain choker
from limb before continuing to feed will
result in severe equipment damage and may
result in injury or death.
Step 13: Detach choker from limb and remove winch
line and choker from path of feeding
materials.
Step 14: Hook winch line loop on interlock hook (6).
Step 15: Use Winch Retract/Extend Lever (4) to
retract winch line until the interlock hook (6)
slides back and locks.
Step 16: If necessary, place Upper Feed Control Bar
(7) in FORWARD to feed remainder of limb
into chipper. Press Hold-to-Run Button (5) to
start feeding.
To continue pulling limbs, repeat Steps 2–16.
Step 17:
Step 18: Store winch line and choker. Refer to
Line - Store (BC1200XL Only), page 30-11.
50-22 Operating the Brush Chipper
4
6
5
Winch
7
LEFT SIDE CONTROLS (OPTION)
4
6
5
7
BC1200XL Brush Chipper