Engine Fault Codes (110/120-Hp Engine) - Vermeer BC1200XL Operator's Manual

Section 62: Engine Fault Codes (110/120-HP Engine)
Refer to the Engine Operation Manual for additional information on understanding and recording engine fault
codes displayed on engine multifunction display, and appropriate remedial actions. Always contact your
Vermeer dealer or engine service dealer for help in correcting diagnostic trouble codes which are displayed for
your engine.
NOTE: The first part of the code is a six-digit Suspect Parameter Number (SPN) which identifies the system or
component that failed, followed by a two-digit Failure Mode Identifier (FMI) code which identifies the type of
failure (example: high temperature). In order to determine the exact failure both parts of the code are needed.
Fault
SPN FMI Light
Code
111 000629 12 Red
115 000612 02 Red
122 000102 03 Amber
123 000102 04 Amber
124 000102 16 Amber
131 000091 03 Red
BC1200XL Brush Chipper
DESCRIPTION
ECU Programming Error (Critical Internal Failure - Bad
Intelligent Device or Component)
System Diagnostic #2 (Engine Speed/Position Sensor Circuit
Lost Both Signals from Magnetic Pickup Sensor - Data Erratic,
Intermittent, or Incorrect)
Boost Pressure (Intake Manifold Air Pressure Sensor Circuit -
Voltage Above Normal or Shorted to High Source)
Boost Pressure (Intake Manifold Air Pressure Sensor Circuit -
Voltage Below Normal, or Shorted to Low Source)
(110-hp only) Boost Pressure (Intake Manifold 1 Air Pressure -
Data Valid but Above Normal Operational Range - Moderately
Severe Level)
Throttle Position Sensor Circuit - Voltage Above Normal, or
Shorted to High Source
CORRECTIVE ACTION
Contact Servicing Dealer
Check Sensor and Wiring
Contact Servicing Dealer
Contact Servicing Dealer
Contact Servicing Dealer
Check Switch and Wiring

Engine Fault Codes (110/120-HP Engine) 62-1