Starting Procedure; Starting The Engine; Cold Weather Starting; Engine - Vermeer BC1200XL Operator's Manual

Section 22: Starting Procedure
S E
TARTING THE NGINE
Step 1: Place Cutter Engage/Throttle Lever in DISENGAGED/LOW RPM.
Step 2: Place Upper Feed Control Bar in top STOP position.
Turn keyswitch to preheat/ON position.
Step 3:
Step 4: 110-HP Engine (Option): After white Preheat Indicator Light (1) turns
off, turn key fully clockwise to start the engine. Release key once the engine
starts.
120-HP Engine (Option): After the wait to start turns off in display panel
(1), turn key fully clockwise to start the engine. Release key once the
engine starts.
IMPORTANT: Never run the starter motor for more than 30 seconds at a time. Allow
starter motor to cool 1 minute between attempts.
Step 5: Allow engine to warm up for 3–5 minutes before engaging the cutter.
IMPORTANT: Do not idle engine for more than 10 minutes. The resulting low
temperatures in the combustion chamber will not allow fuel to burn completely and
can cause engine damage.
C W S
OLD EATHER TARTING

Engine

Before operating in cold weather (below 32°F (0°C)), refer to the Engine Operation Manual for recommended
engine oil, fuel, and starting procedures.
BC1200XL Brush Chipper
1
110-HP Engine
1
120-HP Engine

Starting Procedure 22-1